Warming up the iron…Drag to rotate · scroll or pinch to zoom
Shopping list
0%| Color | Code | Beads | |
|---|---|---|---|
| ALemon | 80-15269 | 574 | |
| BSunflower | 80-15268 | 342 | |
| CBlack | 80-19018 | 48 | |
| DFlamingo | 80-15203 | 28 | |
| EYellow | 80-19003 | 20 | |
| FCheddar | 80-19057 | 4 | |
| Total | 1016 |
About this pattern
Spinning star is a free 20×19 fuse bead pattern by Nori. It uses 102 beads in 6 colors, fits on 1 square pegboard(s) and takes about 15 minutes to place, plus ironing. It was made with Perler beads — switch the shopping list to another brand and every color is matched to the closest bead you can buy.
It is also an animation with 10 frames: build each frame as its own piece, or keep the GIF to share.
How to make it
- Sort the colors from the shopping list into small bowls — one per color makes placing much faster.
- Place the beads on the pegboard row by row, following the Pattern tab. Tick off each color as you finish it.
- Cover the design with ironing paper and iron on medium heat in slow circles for 10–20 seconds, until the beads fuse.
- Let it cool under a heavy book so it stays flat, then peel off the paper and lift it off the board.
- Flip the piece and iron the back lightly for extra strength.
Tips
- Keep the iron moving in slow circles — pressing in one spot leaves flat dimples.
- Medium heat and a little patience give the classic look where the bead holes stay open.
- Buying beads? Get 10–20% extra of each color in case some are off-color or roll away.
What you need
- 1 × square pegboard (29×29)
- 102 Perler beads in 6 colors
- Ironing paper or parchment
- A household iron (steam off)
FAQ
How many beads do I need for Spinning star?
102 beads in 6 colors. The most used is Lemon, with 574 beads; the full list with color codes is in the shopping list.
What size pegboard do I need?
The design is 20×19 beads, so it needs 1 standard 29×29 square pegboard(s). Larger boards that clip together work too.
How long does it take to make?
About 15 minutes to place the beads, plus a few minutes to iron and cool.
Can I use Hama, Artkal or MARD beads instead?
Yes. It was made with Perler, but you can switch the brand above the shopping list and BeadPop matches every color to the closest bead of that brand. All 5 mm midi beads fit the same pegboards.
Can I print the pattern?
Yes — download the PDF chart for a printable, board-by-board version with symbols and a color list, or save the whole chart as a PNG.







