How to iron fuse beads
Ironing is where the magic happens: loose beads fuse into one sturdy piece. It only takes a few minutes — here is how to get it just right.
What you need
- Your finished design on a pegboard
- Ironing paper (baking paper works too)
- A household iron with no water in it
- A heavy book for cooling
- A grown-up helper for younger crafters
Step by step
- 1
Set the iron to medium heat (no steam) and let it warm up for a few minutes.
- 2
Lay the ironing paper over your design so every bead is covered.
- 3
Move the iron in slow, small circles for 10–20 seconds. Keep it moving!
- 4
Lift a corner of the paper: the holes should be smaller but still open. Iron a little more if beads are loose.
- 5
Let it cool for a minute, then peel the piece off the pegboard, flip it and iron the back the same way.
- 6
Put it under a heavy book while it cools so it stays perfectly flat.
Safety first: irons get very hot. Kids should always iron with an adult nearby.
Little tricks
- Use the Iron slider in our 3D preview to decide how melted you want your piece to look.
- Lightly fused beads look cute and round; fully fused pieces are sturdier for coasters and keychains.
- Iron large pieces one area at a time so the middle does not get overcooked.
Oops! Quick fixes
Beads are falling off
Iron a little longer or at slightly higher heat, with gentle even pressure.
The holes closed up completely
Totally fine for sturdy pieces. Next time use lower heat or fewer seconds.
My piece curled up
Warm it again briefly and cool it under a heavy book. Iron both sides evenly.