Warming up the iron…

Drag to rotate · scroll or pinch to zoom

Shopping list

0%
ColorCodeBeads
AGreen80-19080144
BLight Brown80-1902132
CRich Butter80-152748
DHot Coral80-190593
EPastel Blue80-190522
Total189

About this pattern

Standing Christmas tree is a slot-together 3D bead figure by Mira: flat pieces, each with a one-bead slot, that slide into each other and stand on their own. It uses 189 beads in 5 colors; placing the beads takes about 15 minutes.

How to make it

  1. Build every piece on its own pegboard, following the Pattern tab — leave the dashed slot columns empty.
  2. Iron every piece on both sides until all the beads have fused.
  3. Let them cool flat under a book. If the iron closed a slot, push a pin through to open it again.
  4. Slide each crossing piece into the main piece at a right angle until the slots meet — from the top, or from below for legs and axles.
  5. Stand it up — it holds without glue. Tie a thread to the top to hang it as an ornament.

Tips

  • Keep the iron moving in slow circles — pressing in one spot leaves flat dimples.
  • Medium heat and a little patience give the classic look where the bead holes stay open.
  • Buying beads? Get 10–20% extra of each color in case some are off-color or roll away.

What you need

  • 1 × square pegboard (29×29)
  • 189 Perler beads in 5 colors
  • Ironing paper or parchment
  • A household iron (steam off)
  • No glue: the pieces slot together (a pin helps reopen a slot)

FAQ

How many beads do I need for Standing Christmas tree?

189 beads in 5 colors. The most used is Green, with 144 beads; the full list with color codes is in the shopping list.

What size pegboard do I need?

Each face fits within a 27×17 area of a standard square pegboard.

How long does it take to make?

About 15 minutes to place the beads, plus a few minutes to iron and cool.

Can I use Hama, Artkal or MARD beads instead?

Yes. It was made with Perler, but you can switch the brand above the shopping list and BeadPop matches every color to the closest bead of that brand. All 5 mm midi beads fit the same pegboards.

Can I print the pattern?

Yes — download the PDF chart for a printable, board-by-board version with symbols and a color list, or save the whole chart as a PNG.

More by Mira

All works

More patterns to try